Amiga reset cable connection

From Classicamiga

(Difference between revisions)
Jump to: navigation, search
(Project details)
(Project details)
Line 22: Line 22:
Locate the small dots on the A1200 Board, they are near to the PCMCIA, you will see two parallel lines of dots. It is the one that is
Locate the small dots on the A1200 Board, they are near to the PCMCIA, you will see two parallel lines of dots. It is the one that is
-
most near the PCMCIA and the two dots you have to work on are again the two more nere the PCMCIA:
+
most near the PCMCIA and the two dots you have to work on are again the two more near the PCMCIA:
[[Image:a1200_reset_before_low.jpg]]
[[Image:a1200_reset_before_low.jpg]]

Revision as of 17:59, 13 December 2008

Amiga reset cable connection

Amiga reset cable connection
Created 2008
Creator Tiago
Based On n/a

Contents

Hardware Spec/Parts Needed

  • A1200 Board
  • Reset cable
  • Pins
  • Soldering Iron

Project details

This hardware project forms part of the larger Micronik Infinitiv A1200 Tower Case Project.

This small project is designed to allow the A1200 Tower to reset just like the key combination (Ctrl+A+A). A1200 Boards are prepered to receive a reset cable switch. All you have to do is connect two small dots on the board, with a switch in between. When you press down the switch the Amiga will reboot with the same result as (Ctrl+A+A)


Locate the small dots on the A1200 Board, they are near to the PCMCIA, you will see two parallel lines of dots. It is the one that is most near the PCMCIA and the two dots you have to work on are again the two more near the PCMCIA:

Image:a1200_reset_before_low.jpg


For this project i grab an old pc sound card, that wasn't working and i remove 2 pins inside a small piece of plastic that holds them. After some soldering work to fix them them to the board, connecting the pins to the 2 metal dots.

Image:a1200_reset_pins_low.jpg


My tower allready had a switch ready, so i needed only to connect the connect the cable to the pins. But if you don't have one, all you needis to get a swith and connect to cables to it, and them to the pins, easy.

Image:a1200_reset_cable_pins_low.jpg.

Project Gallery


Additional Reading

See also:

Personal tools
Classicamiga Directories