Buffered IDE Interface (A1200/A600)

From Classicamiga

Revision as of 18:25, 29 November 2008 by Tiago (Talk | contribs)
(diff) ←Older revision | Current revision (diff) | Newer revision→ (diff)
Jump to: navigation, search
Editing IDE Interface - connect to HD

Editing IDE Interface - connect to HD
Created 2008
Creator Tiago
Based On Custom hardware
Kickstart n/a
Operating System n/a
CPU n/a
Memory n/a


Contents

Project details

The IDE interface usually is a small circuit with connections to IDE 2.5" and 3.5". In this case, the "Eyetech MK4" cames with:

  • The circuit (interface)
  • with a 2,5" cable
  • 1 floppy disk with drivers/software

In this example we have a standard A1200 case, so to install, we have to:

  • open the A1200 case, carefull, there are a lot of cases that the screws are hard to remove, and you could damage the case if you use to many force.
  • locate your HD, if any, in a standard a1200 case should be a 2.5", but it's possible to have a 3.5". Remove the IDE cable from HD
  • if you had the HD you allready have a 44 pin cable of 2.5" connected to the board, if not, find the 44 pin in the board on the left part, and insert the cable.
  • connect the other end of the cable to IDE interface where it says "internal HD" it has 44 pins.
  • connect the HD to interface, if it is a 2.5" connect to the other 44 pin available, if you have a 3.5" connect to one of the two 40 pin connecters available, it should work on both. You can also use an adapter from 3.5" to 2.5"
  • you can also connect a cd-rom, to do so, connect it to the "ch2s" and leave the ch2m to the HD.

The cable stripes goes all to the left, see pictures.



Project Gallery


Additional Reading

Reference

Personal tools
Classicamiga Directories