Buffered IDE Interface (A1200/A600)

From Classicamiga

(Difference between revisions)
Jump to: navigation, search
(Project Gallery)
Line 1: Line 1:
{{Infobox DIY
{{Infobox DIY
|Image = ide interface connect eyetech MK4_4 .JPG  
|Image = ide interface connect eyetech MK4_4 .JPG  
-
|Caption = Editing IDE Interface - connect to HD
+
|Caption = Buffered IDE Interface
-
|Name = Editing IDE Interface - connect to HD
+
|Name = Buffered IDE Interface - connect to HD
|Created = 2008
|Created = 2008
|Creator = [[User:Tiago|Tiago]]
|Creator = [[User:Tiago|Tiago]]
-
|Based = Custom hardware
+
|Based = [[A1200]]/[[A600]]
-
|Kickstart = n/a
+
|Kickstart = [[Kickstart Roms Explained|2.05/3.X]]
-
|OS = n/a
+
|OS = 2.1/3.X
-
|CPU = n/a
+
|CPU = any
-
|Memory = n/a
+
|Memory = any
}}
}}

Revision as of 15:32, 3 December 2008

Buffered IDE Interface - connect to HD

Buffered IDE Interface
Created 2008
Creator Tiago
Based On A1200/A600
Kickstart 2.05/3.X
Operating System 2.1/3.X
CPU any
Memory any


Contents

Project details

The IDE interface usually is a small circuit with connections to IDE 2.5" and 3.5". In this case, the "Eyetech MK4" cames with:

  • The circuit (interface)
  • IDE 2,5" cable
  • 1 floppy disk with drivers/software

In this example we have a standard A1200 case, so to install, we have to:

  • open the A1200 case, carefull, there are a lot of cases that the screws are hard to remove, and you could damage the case if you use to many force.
  • locate your HD, if any, in a standard a1200 case should be a 2.5", but it's possible to have a 3.5". Remove the IDE cable from HD
  • if you had the HD you allready have a 44 pin cable of 2.5" connected to the board, if not, find the 44 pin in the board on

the left part, and insert the cable.

  • connect the other end of the cable to IDE interface where it says "internal HD" it has 44 pins.
  • connect the HD to interface, if it is a 2.5" connect to the other 44 pin available, if you have a 3.5" connect to one of the two 40 pin connecters available, it should work on both. You can also use an adapter from 3.5" to 2.5"
  • you can also connect a cd-rom, to do so, connect it to the "ch2s" and leave the ch2m to the HD.

The cable stripes goes all to the left, see gallery pictures .

An example of IDE Interface use could be something like this Micronik Infinitiv A1200 Tower Case Project

Project Gallery

Additional Reading

Reference

Personal tools
Classicamiga Directories